Installation Kits and Components

For collector mount on a pitched roof, roof anchors are used that are fixed to the supporting part of the roof, or to an auxiliary board. Roof anchors shall be selected with respect to the type and composition of the roofing. Collector installation on flat roofs is done in the same manner as on pitched roofs, just the roof inclination and roof anchors are substituted by a triangle-shaped support structure. A special fixing and interconnection kit shall be used to fix and connect collectors mutually, depending on the number of collectors. This kit is intended to install the collectors into one array and connect them mutually. A connection kit is then needed that connects such an array to incoming and outgoing piping, involves plugs for unused collector in-/outlets as well as controller sensor sheath and air bleed termination (depending on the collector type).

:
page: 2
Picture: Mount and interconnection kit for 4 KPG1 collectors
Mounting rails, retaining bottom and side clamps, bolts, nuts, insulation, straight pipe fittings. Either 10 roof anchors (inclined roof) or 5 supports and 1 strut (flat roof) shall be ordered for roof mount.
in stock
Code: 10541
Picture: Mount and interconnection kit for 5 KPG1 collectors
Mounting rails, retaining bottom and side clamps, bolts, nuts, insulation, straight pipe fittings. Either 12 roof anchors or 6 supports and 1 strut shall be ordered for roof mount, depending on the roof type.
in stock
Code: 14067
page: 2