3 - WAY MIXING VALVES, THREADED, SERIES 2000 TYPE: VM3, VDM3
Materials:
Valve body cast iron
Rotor: cast iron
Anchor screws: steel
Cover: aluminium
Bush: aluminium
Ring gaskets : EPDM
Type
VM3, VDM3*
Nominal diameter:
DN
20
25
32
40
Nominal flow rate:
Kvs m3/h
18 (20*)
22 (22*)
22 (25*)
22 (25*)
Rated pressure:
PN
6
Max. working temperature:
t max
110°C
Max. pressure difference:
Dpmax
100 kPa
Max. rotation:
j
90°
Leakage A-AB:
=< 0,1% z Kvs
Leakage A-B:
=< 0,5% z Kvs
Type of the recommended servomotor:
V200; 18 Nm; 60,90,120,240,480 s., V70; 7 Nm; 60,90,120,240,480 s.,
Identification number
VM3
 7.007.00176.0 7.007.00177.0 7.007.00178.0 7.007.00179.0
VDM3
 7.007.00181.0 7.007.00182.0 7.007.00183.0 7.007.00184.0

VM 3 - 3-way mixing valve with butterfly hut - off
VDM 3 - 3-way mixing valve with circular segments 		Overall dimensions
VM3,VDM3

Æ
DIMENSIONS mm
DN
UNI
A
B
C
D
E
F
20
G3/4"
100
50
37
105
34
45
25
G1"
100
50
37
105
34
50
32
G1 1/4"
110
55
37
105
34
60
40
G1 1/2"
120
60
37
105
34
65

Mixing valve identification :
 Specify the following data for exact valve identification :
Series
Type
Diameter mm
DN
"
2000
VM3
 3 - way with butterfly shut-off
32
1 1/4"
Example: 2000 VM3 32: 3-way mixing valve series 2000 with butterfly shut-off,
, threaded G11/4" (DN32) according to ISO 228.

Spare parts codes

Description
1
 valve body
2
 bush
3
 rotor
4
 felt + seal washer + O ring + flat gasket + cover + cover fastening screws
5
 bush + O ring + rotor + seal washer + plate + felt + gaskets
6
 handle + handle fastening screws
Application example

Installation diagram for a 3-way mixing valve with a butterfly shut-off

Installation diagram for a 3-way mixing valve with circular segments - function: mixing

Installation diagram for a 3-way mixing valve with circular segments - Function : diverting
Note
 Valves are furnished standard with right inlets.
Proceed as follows whenever it is necessary to invert the inlet:
1) remove the manual lever and the metal label
2) remove the valve cover and extract the internal rotor
3) rotate the internal aluminium bush 180° so that the profiled
path is positioned at the opposite side
4) reinstall the internal rotor in the same position
5) reinstall the metal label upside down from its previous position
6) The valve must be installed in the plumbing circuit according to the flow direction specified on the valve.
 Main characteristics
Mut valves are made with cast-iron bodies and internal rotors. Rotor rotation angle is about 90°. Mixing is done by a circular segment rotor in models VDM and by a butterfly valve in models VM. Mut valves are furnished with manual controls but can be easily motorised using motors and valve-motor connections marketed by manufacturers of regulation components.