Installation Kits and Components

In this section, you will find mounting components and kits that ensure the safe and stable mounting of solar collectors on both pitched and flat roofs and their proper connection into a functional unit.
To mount solar collectors on a pitched roof, roof hooks anchored to the load-bearing part of the roof truss or to an added support board. Roof hooks must be selected with regard to the type and composition of the roofing material. read more

Installation on flat roofs is performed similarly to that on sloped roofs, with the required collector tilt ensured by triangular support structure, which in this case replaces the roof hooks.

To assemble the collectors into a single array and connect them to each other, use mounting and connection kits based on the number of collectors. For each solar array, you need to use connection kit, which handles the connection of the array to the inlet and outlet piping, the capping of unused collector outlets, and, depending on the collector type, also includes a well for the control sensor and an outlet for venting the array.

49 products

KPS1 collector mounting and connection kit

Mounting rails, retaining bottom and side clamps, bolts, nuts, insulation. Either 4 roof anchors (inclined roof) or 2 supports and 1 strut (flat roof) shall be ordered for roof mount.

Mount kit for KPS11 solar collector

Mounting rails, retaining bottom and side clamps, bolts, nuts, insulation. Either 4 roof anchors (inclined roof) or 2 supports and 1 strut (flat roof) shall be ordered for roof mount.

Mounting and connection kit for KPG1 collectors

Mounting rails, retaining bottom and side clamps, bolts, nuts, insulation. Either 4 roof anchors (inclined roof) or 2 supports and 1 strut (flat roof) shall be ordered for roof mount.

Kit for mounting and connecting KPG1H collectors

Mounting rails, retaining bottom and side clamps, bolts, nuts, insulation. Either 4 roof anchors (inclined roof) or 2 supports and 1 strut (flat roof) shall be ordered for roof mount.